PorscheTaycan.pdf

(5266 KB) Pobierz
Porsche AG, Taycan, all derivatives,
Limousine
from Model Year 2019
High voltage!
Secondary emergency disconnection point
Primary emergency
disconnection point
Airbag
Gas
generator
Seat belt pre-
tensioner
Pedestrian
protection
system
Body
reinforce-
ment
Gas
strut
SRS-
Control unit
12-volt
battery
Fuse
box
High
voltage
battery
High voltage
cable/
component
High
voltage
cut-off
ID no. EN-01-710-0078
version no. 1
page 1 of 4
1.
Identification / recognition
The Porsche Taycan is only available with electric drive.
The Porsche Taycan can be identified by its body design, the
logo at the rear (can also be deselected) and the electric sym-
bols at the instrument panel.
2.
Immobilisation / stabilisation / lifting
Press switch
P
Parking brake will be automatically activated
3.
Disable direct hazards / safety regulations
Switch
off
ignition
Press
START-STOP
switch
without
pressing the footbrake.
5m
Lack of engine noise does
not
mean
that
the
ignition
is off.
A restart is possible until the
ignition is switched off.
Deactivation of high voltage system
The high voltage system is automatically
switched off in case of a crash with air-
bag(s) deployment.
For all other cases, deactivate the high voltage system as follows:
ID no. EN-01-710-0078
version no. 1
page 2 of 4
Deactivation of high voltage system
Option 1 -
Primary emergency disconnection point:
B
Remove the cover.
1.
Unlock -A-
2.
and unplug -a- the service plug (marked with
the
flag
B).
1
2
a
B
A
Option 2 -
Secondary emergency disconnection point:
1.
2.
3.
Remove the side cover in the right-hand side of the boot.
Remove the retaining frame (K) from the fuse block.
Unplug fuse number
1
(marked with
the
flag
A).
1
2
K
3
A
9J1.0
1
To ensure that there is no remaining voltage in the high voltage system
wait approx. 20 seconds after switching it off.
The passive safety systems, such as airbags and seat belt pre-tensioners,
are still supplied with voltage from the on-board 12-volt battery.
Disconnect 12 V battery
Option 1 - Remove cabel 12-V in the front:
1. Remove the cover of the 12-volt battery on the rear
right-hand side of the luggage compartment.
2. Disconnect the negative cable of the 12-volt battery and secure
it to prevent accidental contact.
The passive safety systems
(airbags and seat belt
pre-tensioners) are deactivated.
1
2
ID no. EN-01-710-0078
version no. 1
page 3 of 4
4.
Access to the occupants
For the extrication of the occupants the zones of the bodywork consisting of high-strength steels
and the components of the restraint systems (especially pyrotechnic elements) should be taken
into account as indicated in page
1.
Additional deformation of the sills and the underbody during the rescue
(e.g. support with hydraulic equipment) must be avoided.
5.
Stored engery / liquids / gases / solids
LI ION
High voltage cable have orange coloured isolation.
NEVER cut, breach or touch high voltage components or cabling.
This could result in serious injuries or death.
6.
In case of fire
In case of vehicle burn use large amounts of water (H
2
O).
Warning: battery re-ignition
7.
In case of submersion
There is no risk of voltage being present on the vehicle body.
After recovering the vehicle:
1.
drain the water out of the vehicle
2.
and initiate the deactivation of the high voltage system (see chapter
3).
8.
Towing / transportation / storage
Transport the vehicle only with both axes on a tow truck or car transporter.
Store at safe distance from other vehicles
Warning: battery re-ignition
9.
Important additional information
Additional information about accident assistance and recovery of vehicles with high voltage
systems can be found at https://www.vda.de/en/services/Publications/rescue-and-towing-of-ve-
hicles-with-high-voltage-systems.html
ID no. EN-01-710-0078
version no. 1
page 4 of 4

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika:

Zgłoś jeśli naruszono regulamin