DCF39 Notch filter.pdf

(257 KB) Pobierz

A notch filter for DCF39Alan Melia (

https://g3nyk.ham-radio-op.net/BR_t_Notch.htm

A notch filter for DCF39

Alan Melia (G3NYK) and Hugh (M0WYE)

After discussions with Hugh M0WYE, I sent him the circuit and parameter value for a notch filter that

should reduce the strength of the German utility station DCF39 on 138.83 kHz by 30 to 40dB without

giving more than a couple of dB loss inside the amateur 136kHz band. He made a quick practical example

of the circuit with a small inductor and achieved results very similar to my simulations. This is offered as

a possible experimental solution with no guarantees that it will work in every situation.

The simulation has been made with a coil resistance of 0.1 ohm, so a quite easily achieveable Q. Hugh

managed to get a small ferrite bobbin coil (rewinding it with a centre tap) to meet this requirement. The

higher the Q of the coil the higher is the resistance required to set the best notch depth. According to

Terman (Radio Engineer's Handbook 1943) This should be a quarter of the parallel resonant impedance of

the LC circuit. As far as I can see at the moment the only problem is that the output of the filter must not

be loaded too heavily, so a FET source follower is probably called for ( J310 running reasonable amount

of source current to keep the IMDs down ??). The simulation used a 10k0 load and lower values lead to a

reduction in notch depth and sharpness. For practical purposes the capacitor C needs to have some

propotion of the capacity variable to tune the notch in "on the nose". Then the resistor is adusted for

maximum attenuation. It is very sharp, and it may not be possible to achieve best attenuation with a single

sweep trimmer. You will need to experiment with the components you select to use. The simulation uses

the AC Analysis program available as PD freeware in my Programs area

1z2

02.10.2020, 00:31

A notch filter for DCF39Alan Melia (

https://g3nyk.ham-radio-op.net/BR_t_Notch.htm

Return to homepage

2z2

02.10.2020, 00:31