Raspberry-Pi-Enclosure-v1-Assembly.pdf

(643 KB) Pobierz
Raspberry Pi Enclosure v1 Assembly
Raspberry Pi Enclosure v1
Assembly
Written By: Eric Weinhoffer
PARTS:
Raspberry Pi Enclosure (1)
SUMMARY
This guide will show you how to assemble the simple Pi enclosure that's included in the
Maker Shed
Raspberry Pi Starter Kit.
If you have v2 of the enclosure (if there's nuts and bolts in the bag), go
here.
© Make Projects
www.makeprojects.com
Page 1 of 4
Raspberry Pi Enclosure v1 Assembly
Step 1 — Raspberry Pi Enclosure v1 Assembly
You should have nine parts in total:
four side pieces, one bottom piece,
and four small locks.
If your parts look a lot
different, and there are
some nuts and bolts in the bag as
well, head over to the
v2
instructions.
Step 2
Place your Raspberry Pi onto the
bottom piece. The headers, SD
card slot, and USB power port
should be above the side with the
two small rectangles.
© Make Projects
www.makeprojects.com
Page 2 of 4
Raspberry Pi Enclosure v1 Assembly
Step 3
Now attach the two smaller sides, and hold the whole assembly in your hand as shown.
The side piece with the "Make: Pi" engraving should line up with the SD card slot on
your Pi - you may have to push the Pi into place.
Step 4
Now slide the two larger side pieces into place. It doesn't matter what order you assemble
them in.
You may have to put some pressure on the side pieces to get everything to fit
together nicely, but that's ok, it's supposed to be a tight fit.
If you're using the included Pi Cobbler, install it on the headers and slide the ribbon
cable through the side piece before assembling.
© Make Projects
www.makeprojects.com
Page 3 of 4
Raspberry Pi Enclosure v1 Assembly
Step 5
Now insert the four small lock
pieces into their slots.
That's it, you're done!
This document was last generated on 2013-01-28 05:52:01 PM.
© Make Projects
www.makeprojects.com
Page 4 of 4

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika:

Zgłoś jeśli naruszono regulamin