Raspberry Pi Enclosure v1 Assembly Make] Projects hhiiilH ho/ 1 !/ tuMaal/ chare r\icf*f\\tat* build, hack, tweak, share, discover,- Raspberry Pi Enclosure vl Assembly Written By: Eric Weinhoffer O PARTS: Raspberry Pi Enclosure (1) SUMMARY This guide will show you how to assemble the simple Pi enclosure that's included in the Maker Shed Raspberry Pi Starter Kit . If you have v2 of the enclosure (if there's nuts and bolts in the bag), go here . © Make Projects www.makeprojects.com Page 1 of 4 Raspberry Pi Enclosure v1 Assembly Step 1 — Raspberry Pi Enclosure vl Assembly • You should have nine parts in total: four side pieces, one bottom piece, and four small locks. • If your parts look a lot different, and there are some nuts and bolts in the bag as well, head over to the v2 instructions. A Step 2 • Place your Raspberry Pi onto the bottom piece. The headers, SD card slot, and USB power port should be above the side with the two small rectangles. © Make Projects www.makeprojects.com Page 2 of 4 Raspberry Pi Enclosure v1 Assembly Step 3 • Now attach the two smaller sides, and hold the whole assembly in your hand as shown • The side piece with the "Make: Pi" engraving should line up with the SD card slot on your Pi - you may have to push the Pi into place. a Step 4 • Now slide the two larger side pieces into place. It doesn't matter what order you assemble them in. # You may have to put some pressure on the side pieces to get everything to fit together nicely, but that's ok, it's supposed to be a tight fit. • If you're using the included Pi Cobbler, install it on the headers and slide the ribbon cable through the side piece before assembling. © Make Projects www.makeprojects.com Page 3 of 4 Raspberry Pi Enclosure v1 Assembly Step 5 • Now insert the four small lock pieces into their slots. • That's it, you're done! This document was last generated on 201 3-01 -28 05:52:01 PM. © Make Projects www.makeprojects.com Page 4 of 4
Amiga789