Raspberry-Pi-Enclosure-v2-Assembly.pdf

(773 KB) Pobierz
Raspberry Pi Enclosure v2 Assembly
Raspberry Pi Enclosure v2
Assembly
Written By: Eric Weinhoffer
TOOLS:
Phillips head screwdriver (1)
PARTS:
Raspberry Pi Enclosure (1)
SUMMARY
How to assemble the enclosure that's included in the
Raspberry Pi Starter Kit.
© Make Projects
www.makeprojects.com
Page 1 of 5
Raspberry Pi Enclosure v2 Assembly
Step 1 — Raspberry Pi Enclosure v2 Assembly
Make sure you have everything
needed for assembly. The bag of
parts should include six blue
acrylic pieces, four nuts, and four
bolts.
Your parts may have a
different etching, but don't
worry, they'll fit together just as
well.
If you have nine acrylic
pieces and no nuts or bolts,
you have v1 of the enclosure. See
assembly instructions
here.
Step 2
Fit the small acrylic piece with "LAN" and "USB" etched in it onto the PCB as shown, with
the text facing out.
Now slide the bottom piece (the one with the URLs) into the two small cutouts of the side
piece, with the text facing out.
The SD Card slot on the opposite side of the PCB should rest on the bottom piece.
If you'd like to use the
Raspberry Pi Cobbler
with your Pi, install it now.
© Make Projects
www.makeprojects.com
Page 2 of 5
Raspberry Pi Enclosure v2 Assembly
Step 3
Hold the assembly in one hand,
and slide the top piece into place
with the other, with the text facing
up.
This piece is optional, but
we recommend you use it,
since it will add substantial
structural support to the whole
enclosure. If you want to go on
without it (you can always add it
later), skip this step.
Step 4
Now add the other small side piece
- the one with "Make: Pi," "SD" and
"PWR" etched on it. Again, the text
should face out.
Make sure the two small
sides are parallel to each
other. There should be very little
wiggle room for the PCB.
© Make Projects
www.makeprojects.com
Page 3 of 5
Raspberry Pi Enclosure v2 Assembly
Step 5
Next, add the larger side piece with "AUDIO" and "VIDEO" etched on it to the enclosure.
Snap it into place!
If you have a Pi Cobbler installed, slide the ribbon cable into the cutout on the right
side of this piece before snapping it into place.
Now add the final side piece. As always, the text should face out.
Step 6
Now it's time to fasten everything together! Hold the enclosure on its side and insert one of
the nuts. Insert a bolt through one of the side pieces and screw it in. Repeat this four times
to assemble the whole box.
If one of the nuts falls into the enclosure, don't worry. You should be able to guide it
out through one of the holes.
© Make Projects
www.makeprojects.com
Page 4 of 5
Raspberry Pi Enclosure v2 Assembly
Step 7
That's it! Enjoy your Raspberry Pi.
This document was last generated on 2012-12-01 06:17:42 PM.
© Make Projects
www.makeprojects.com
Page 5 of 5

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika:

Zgłoś jeśli naruszono regulamin