Flasher Quick Start.pdf

(394 KB) Pobierz
The J2534 Flasher Quick Start Guide
INSTALLING THE J2534 FLASHER
1. Confirm the kit contents
a. The J2534 Flasher -
P/N 01002902
b. Installation CD
- P/N 02003266
c. USB Cable
- P/N 06501262
d. Data Link Connector Cable
- P/N 02003204
e. RS232 Cable (optional)
- P/N 06500124
a
d
b
c
e
2. Install the Software
a. Insert the CD into the CD or
DVD drive. If the CD does
not auto-run, navigate to the
CD drive and double-click
Setup.exe.
b. Click
Next
from the
Welcome
Screen.
c. Read the License Agreement
and click
Yes
to continue.
d. Click
Next
to confirm the
installation directory.
e. Click
Next
to confirm the
Program folder.
f. Click
OK
to complete the
installation.
f
e
a
b
Version x.xx
c
d
3. Hardware Setup
a. Connect the USB cable and the Data Link
Connector cable to the .
Note: A USB cable has been
furnished with this kit as USB
offers substantially better
performance and faster
communication. Selection of the
COM Port is not necessary since
the USB cable will auto-
configure.
b. Attach the USB cable to the PC.
c. Connect the Data Link
Connector cable to the vehicle’s
SAE J1962 DLC port.
Note: The vehicle’s SAE J1962
DLC port should be easily
accessible from the driver’s seat. In most
cases, the SAE J1962 DLC can be found
within 3 feet of the steering wheel.
CAUTION!
CAUTION
Vehicle DLC
c
a
b
Do not disconnect the USB cable or Data
Link Connector cable during operation.
4. Test the
a. Click
Start
and select
Programs > Vetronix >
a
ES6510 > ES6510 Utility
to launch the
application.
Note: The J2534 Flasher must be connected to
a vehicle to supply power and complete the
self-test.
b. Make sure the ignition switch is in the OFF
position.
c. If using an RS232 cable, consult your PC
operator’s manual for instructions on selecting
the appropriate COM port. If using a USB
cable, the configuration is automatic.
d. Select the
Self-Test
tab from the
VPM Utility
screen,
follow the on-screen instructions, and click
Run.
e. Ensure the device is connected properly and then click
Yes
to begin the self-test.
f. The application will run a series of tests to confirm the
hardware and software are operating correctly. All tests
must pass before using The J2534 Flasher.
If the Self Test fails or if you have any questions, please
contact Vetronix Technical Support at 800-321-4889 x2.
d
f
Vetronix Corporation
Copyright
©
2005
08002854 Ver. B
Printed in USA 5/05

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika:

Zgłoś jeśli naruszono regulamin